TM 5-3825-229-14&P
4-10.
REAR AND REMOTE CONTROL BOX (cont)
a.
Removal (cont).
(3) Disconnect cables (3) from control box. Refer to control box wiring diagram and disconnect wiring harness
from instruments, lights, switches and relays. Tag wires.
(4) Remove lock nuts holding cable grips to control box and remove cable grips and wiring harness from control
box.
(5) Remove four locknuts (8) with four washers (7), four bushings (5) and four screws (6).
(6) Remove control box (4) from tool box.
b.
Installation
(1) Install control box (4) in tool box and secure with four screws (6), bushings (5), washers (7) and locknuts (8).
(2) Install harness and cable grips in control box. Slide lock nuts over wires of harness and secure cable grips to
control box with lock nuts.
(3) Refer to control box wiring and connect harness wires to instruments, lights, switches and relays.
(4) Install cover (2) in position on control box and secure with two screws (1).
4-14
