TM 5-3895-370-14&P
F-3. EXPLANATION OF COLUMNS (SECTION II) (CONT).
Code
Application/Explanation
Z
-
Nonreparable item. When unserviceable, condemn and dispose of the item at the level of maintenance
shown in the 3rd position of the SMR code.
O
-
Reparable item. When uneconomically reparable, condemn and dispose of the item at organizational
level F-Reparable item. When uneconomically reparable, condemn and dispose of the item at direct
support level.
H
-
Reparable item. When uneconomically reparable, condemn and dispose of the item at general support
level.
D
-
Reparable item. When beyond lower level repair capability, return to depot. Condemnation and disposal
of item not authorized at below depot level.
L
-
Reparable item. Condemnation and disposal of item not authorized at SRA.
A
-
Item requires special handling or condemnation procedures because of specific reasons (e.g. precious
metal content, high dollar value, critical material, or hazardous material.) Refer to appropriate
manuals/directives for specific instructions.
c. CAGEC (Column (3)). The CAGEC is a 5-digit numeric code which is used to identify the manufacturer,
distributor, or Government agency, etc., that supplies the item.
d. PART NUMBER (Column (4)). Indicates the primary number used by the manufacturer (individual, company,
firm, corporation, or Government activity). which controls the design and characteristics of the item by means of its
engineering drawings, specifications standards, and inspection requirements to identify an item or range of items.
NOTE
When you use an NSN to requisition an item, the item you receive may have a
different part number from the part you ordered.
e. DESCRIPTION AND USABLE ON CODE (UOC) (Column (5)). This column includes the following information.
(1)
Federal item name and, when required, as a minimum description to identify the item.
(2)
number for bulk materials are referenced in this column in the line item entry for the item to be
manufactured/fabricated.
(3)
the Special Tools List section, the BOI appears as the last line(s) in the entry for each special tool, special TMDE,
and other special support equipment. When density of equipment supported exceeds density spread indicated in
the BOI, the total authorization is increased proportionately.
(4)
statement “END OF FIGURE” appears just below the last item description in Column 5 for a given figure in both
Section II and Section III.
f. OTY (Column(6)). The QTY (quantity per figure) column indicates the quantity of the item used the breakout
shown on the illustration figure, which is prepared for a functional group, sub functional group, or an assembly. A WV"
appearing in this column in lieu of a quantity indicates that the quantity is variable and the quantity may vary from
application to application.
F-4
