Section III. OPERATION UNDER USUAL CONDITIONS

Table 2-1. Operator Preventive Maintenance Checks and Services for Forward Area Water Point Supply System (cont)

Figure 2-1. Overall View of Forward Area Water Point Supply System (FAWPSS)

TM-5-4320-301-13P Pump Centrifugal: Self-Priming Diesel Engine Driven Wheel Mounted 8 Inch 1500 GPM at 80 Foot Head (Model US90 CCD-1) Manual
Page Navigation
15

TM 5-4320-301-13&P TM 08936A-13&P/1 Section III. OPERATION UNDER USUAL CONDITIONS 2-5. ASSEMBLY AND PREPARATION FOR USE. 2-6. GENERAL. These procedures describe assembly and preparation for use of the FAWPSS. The system is made up of three major components: water storage drums, a 125 GPM pump, and a water distribution system consisting of several distribution stations. Before attempting to assemble or operate your system, become thoroughly familiar with these three elements. a. To position the two 500-gallon water drums use the lifting and towing yoke assy provided with the system in accordance with TM 10-8110-202-13&P. b. The 125 GPM pump and 3-horse power engine comes fully assembled anc ready for use after proper servicing has been accomplished. This Information is contained in TM 5-2805-257-14 for the engine on Model WPSS100 and in TM 5-4320-309-14 for the engine on Model 9095-91. 2-7. INITIAL ADJUSTMENTS. Inspect the equipment for any damage incurred during shipment. Report any problems to your supervisor. 2-8. ASSEMBLY PROCEDURE a. Selection and Preparation of Assembly Site. (1) (2) Select a level, debris free area approximately 30 feet by 120 feet. Place the 125 GPM pump in position with the female quick-disconnect facing toward the water drums and male toward site chosen for distribution of water see figure 2-1. Prior to assembly of hoses ensure rigid hoses (suction) only are installed between pump and water drums. If this is not done, damage to hoses and pump can occur. Change 4 2-9

Privacy Statement
Press Release
Contact