INSTALLATION INSTRUCTIONS FOR WWF WINDSHIELD WIPERS
(except 1000 Series)
This windshield wiper can be adjusted for 85, 100, 110, and 120 degree wiping angles.
1.
Locate mounting position of wiper assembly.
2.
Determine whether adequate space is available (see
overall dimensions on print on rear.)
3.
Locate approximate stud position on header. See
that blade will wipe the desired area of windshield.
4.
Should a change of wiping angle be needed:
a.
Remove gear case cover.
b.
Remove spring clip on pivot shaft arm.
c.
Lift link and install in desired degrees on gear.
d.
Reverse the above procedure to reassemble.
Wiping angles available are 85, 100, 110, and 120
degrees.
5.
Distance between stud hole & bracket hole should
be 6.25 inches.
6.
Drill tower stud hole first using a 5/8" drill.
7.
Drill mounting bracket hole for a No. 10 screw.
8.
Place the wiper in position and install the mounting
stud attaching nut and washers. Tighten to 30-50 in.
lbs.
9.
Wiring - Diagram shown on rear. On applications
where mounting is of wood, fiber, glass, etc., a
separate ground wire must be attached to the motor
and connected to a battery ground point. A No. 14
wire is recommended.
NOTE - Blade and arm should be mounted approx.
1" minimum away from windshield moulding. Hake
certain the wiper blade does not strike at either end
of the wiping stroke. If blade strikes at both ends, it
will be necessary to shorten the arm and blade
length or reduce the wiping angle of the wiper.
(Refer to # 4.)
MAXIMUM ARM AND BLADE RECOMMENDATION
1 - 15" Arm
1 - 15" Blade
IF 581001
AUGUST 1976