CONTROL PANEL (TYPE 2)
SYSTEMS OPERATION
AMMETER/VOLTMETER SELECTOR SWITCH (AVS)
ACA
Alternating current ammeter
ACV
Alternating current voltmeter
F1,2,3
Fuses
FM
Frequency meter
¤
Terminal point on TS2 in control panel
¤
Terminal Point on TS3 part of voltage
regulator
NOTE: X gives an indication of a
closed contact, X on the line gives an
indication of "make before break"
ACS Engine Control Switch
Engine control switch (ACS) controls the engine start
and stop systems. To start the engine move the switch
to the manual position. To stop the engine. move the
switch to the STOP or OFF position. For standby
application (engine starts when remote initiating contact I
closes) move the switch to the AUTO position. For more
information on the operation of this switch, make
reference to the AUTOMATIC START/STOP SYSTEM..
ACV Alternating Current Voltmeter
AC voltmeter (ACV) shows the potential difference
(voltage) between phase T1-T2, T2-T3 or T3-T1 at
position 1, 2 or 3 respectively. Make reference to the
ALTERNATING CURRENT AMMETER.
DCA Direct Current Ammeter
Direct current ammeter (DCA) goes in place of plug
(1). This ammeter shows the amount of DC current in
amperes, that flows in the alternator circuit (if so
equipped).
ENFL/RE Engine Failure Light/Reset Switch
Engine failure light/reset switch (ENFL/RE) will
activate when the engine has a failure. One or more of
the shutdown indicators will also activate to give an
indication of the problem. Shutdown relay (SR) will
activate to start the shutdown sequence. Make
reference to SHUTDOWN CAUSED BY ENGINE
FAILURE and ENGINE DOES NOT START
174
