CONTROL PANEL (TYPE 3)
SYSTEMS OPERATION
GENERATOR MOUNTED CONTROL PANEL
(TYPE 3 - CHANGE LEVEL 2 THRU 8)
INTRODUCTION
The uses of the generator mounted control panel
are:
To help control the electric power made by the
generator set.
To monitor (check) the operation of' the generator
set.
To help protect the generator set from damage
caused
by
low
oil
pressure,
high
coolant
temperature, overspeed and overcrank.
To help with the transfer of electrical load to and
from the generator set.
To help parallel two or more units onto the same
bus.
IDENTIFICATION
The location of the control panel is on the top of the
regulator housing. This panel has a place for a heat
switch and Prealarm module. The shutdown indicators
are relay lamp type. The control panel has a 12 place
model number on the panel nameplate. The model
number gives an indication of the control panel
component part numbers. Make reference to the Parts
Book, GENERATOR MOUNTED CONTROL PANEL.
Form No. SEBP1068. The last digit of the model
number is the change level to which the panel was built.
WIRING
See the pages that follow for wiring diagrams,
schematics and photo illustrations for identification.
188
