TM 9-2330-267-14&P
Table 4-2. Organizational Troubleshooting (Cont).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 4.
Set multimeter for voltage check. Place red lead (9) in lamp socket, black lead to ground, and
check for 24 volts.
If voltage is not present, go to step 5.
If voltage is present, install new lamp (8).
Step 5.
Disconnect wire 461 (left side) or wire 460 (right side) (11), piace red lead (9) in wire, black lead to
ground, and check for 24 volts.
If no voltage is present, go to step 6.
If voltage is present, connect wiring and go to step 7.
Step 6.
Connect wire 461 or 460 (11) at the
rear harness connector and discon-
nect 461 or 460 wire from wire 22 at
the intervehicular connector. Place
the red lead (9) in wire 22 and check
for 24 volts.
If voltage is present, replace
chassis wiring harness (para
4-25).
If voltage is not present,
replace intervehicular cable
(para 4-27).
TA506994
4-14