TM 10-3835-223-13&P
4-28. HYDRAULIC CYLINDER REPLACEMENT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools required:
Too! Kit, General Mechanics, Automotive (Appendix B, Section III, Item 1)
Material Required:
Tag, Marker (Appendix E, Section II, Item 6)
Suitable caps and plugs
Equipment Condition:
Hydraulic motor and drive wheel removed (para. 4-27)
NOTE
Fluid will drain from hydraulic cylinder when hoses are disconnected.
a.
Removal.
(1)
Remove cotter pin (6). Push pivot pin (7) from frame weldment (5) and cylinder end
cap (3).
(2)
Tag and disconnect two hydraulic hoses (2 and 4) from cylinder (1). Cap hoses and plug
b.
cylinder ports.
(3)
Remove nut (9) from cylinder shaft (8).
(4)
Unscrew clevis (10) from cylinder shaft.
(5)
Remove cylinder (1) from frame weldment
Installation.
(5).
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Connect hydraulic hoses (4 and 2) to cylinder (1) as marked.
Screw cylinder shaft (8) into clevis (10) and install nut (9).
Aline cylinder end cap (3) with frame weldment (5) and install pivot pin (7).
Install cotter pin (6).
Remove tags.
Install hydraulic motor and drive wheel (para. 4-27).
Operate system and check for leaks.
4-54