TM 10-3835-223-13&P
4-24. HOSE REEL REPLACEMENT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools required:
Tool Kit, General Mechanics, Automotive (Appendix B, Section III, Item 1)
Hoist or Crane.
Equipment Condition:
Power pack removed from frame unit (para. 2-8a )
Fuel hose removed from hose reels (para. 2-7a.)
Top frame removed (para. 4-22)
Rollers removed (para. 4-23)
a.
Removal.
WARNING
To prevent injury to personnel and damage to equipment, use lifting device
rated for at least 1,000 pounds.
NOTE
Removal of left hose reel is shown. Removal of right hose reel is similar.
(1)
Connect hoist or crane to center of hose reel (1) spool.
(2)
Remove slack from hoist or crane cable.
(3)
Remove four nuts (5), lockwashers (6), washers (7 and 9), and bolts (10) from two bearing
blocks (8).
(4)
Hoist hose reel (1) from frame weldment (4).
(5)
Loosen setscrews (3) and pull bearing blocks (8) from hose reel shafts (2).
b.
Installation.
WARNING
To prevent injury to personnel and damage to equipment,
be rated for at least 1,000 pounds.
lifting device must
NOTE
Installation of left hose reel is shown. Installation of right hose reel is similar.
(1)
Slide bearing blocks (8) on both hose reel shafts (2).
(2)
Lower replacement hose reel (1) onto frame weldment (4). Aline bearing block mounting
holes with holes in frame weldment.
4-40
