TM 10-3835-223-13&P
4-25. BRAKE REPLACEMENT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools required:
Tool Kit, General Mechanics, Automotive (Appendix B, Section III, Item 1)
Equipment Condition:
Brake side guards removed (para. 4-21)
a.
Removal
NOTE
Removal of left brake is shown. Removal of right brake is similar.
(1)
(2)
(3)
(4)
(5)
Remove locknut (23), washer (22), and screw (21) from brake shaft
weldment (18).
Remove two locknuts (9), screws (3), washers (4 and 6) and spacers (2), from brake
lever (1). Remove brake lever from frame weldment (5).
Remove two nuts (14). lockwashers (13), washers (12 and 8), and screws (7) from shaft
support (11).
Remove two cotter pins (16 and 10). Separate washers (15 and 17) and shaft
support (11) from brake shaft weldment (18).
Remove two screws (19) and brake shoe (20) from brake shaft weldment (18).
b.
Installation.
NOTE
Installation of left brake is shown. Installation of right brake is similar.
(1)
Position brake shoe (20) on shaft weldment (18) and install two screws (19).
(2)
Install cotter pin (10) and flat washer (17) on shaft weldment (18). Position shaft
support (11) on shaft weldment (18) and install flat washer (15) and cotter pin (16).
(3)
AIine shaft support (11) mounting holes with holes in frame weldment (5). Install two
washers (12 and 8), screws (7) , lock washers (13) and nuts (14).
4-42
