TM 10-4130-237-14
5-6.
CYLINDER BLOCK ASSEMBLY REPLACEMENT (CONT)
7
Remove four engine base mounting bolts and four flatwashers. Remove engine base. Remove gasket.
b. Installation
1
2
3
4
5
Install engine base and gasket on cylinder block assembly. Reinstall four engine base mounting bolts
and four flatwashers.
Due to weight of equipment two persons required for next step to prevent
injury and damage to equipment.
Turn engine assembly rightside up.
Install breather assembly and air guide on right cylinder. Install two breather assembly mounting bolts.
Install breather assembly and air guide on left cylinder. Install two breatherassembly mounting bolts.
Install governor shaft lever. Rotate lever left as far as it will go. Hold lever in this position and rotate
governor shaft left as far as it will go.
5-26
