TM 10-4130-237-14
5-17. COMPRESSOR REPLACEMENT (CONT)
9
Remove internal bearing snapring.
10 Remove external bearing snapring.
11 Using puller, remove pulley and bearing assembly.
NOTE
Water chiller, Model LCC-2685, is equipped with a compressor pulley to
match the new centrifugal clutch. On this model, the bearing is retained in a
bearing housing and attached to the pulley with three screws.
12 On water chiller, Model LCC-2685, remove three screws securing the bearing housing and bearing in
the pulley.
b. Installation
1
Drain oil from new compressor. Add 5 oz (148 ml) of this oil back to new compressor.
2
On water chiller, Model LCC2685, insert bearing into the bearing housing and secure to the pulley
with three screws.
3
Install pulley and bearing assembly on compressor shaft Make sure assembly is flush with compressor
front housing hub.
5-57