TM 10-4130-237-146-2.CYLINDER BLOCK ASSEMBLY REPAIR/OVERHAUL (CONT)NOTETwo persons are required for next step.21 Turn engine upside down. Remove four engine base mounting bolts, four flatwashers, and gasket.22 Rotate crankshaft until right piston is at top dead center.NOTEDO NOT interchange parts when removing valves, valve springs, and tap-pets. Tappets must clear cam lobes before camgear can be removed.23 Bend back tabs on connecting rod oil dipper.24 Remove two end cap mounting bolts.25 Pry off end cap.26 Push piston and connecting rod assembly up through right cylinder assembly and set aside.27 Repeat steps 22 through 26 for left cylinder assembly.6 - 7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
