TM 10-4320-303-134.13.8 FrameAssemblyReplacement.This task covers:4.13.8.1 Removal4.13.8.4 Repair4.13.8.2 Disassembly4.13.8.5 Assembly4.13.8.3 InspectionINITIALSETUPToolsEquipmentConditions(Continued)Tool Kit, General Mechanic's,Outlet, Pressure Regulator, Inlet, Drain,Automotive, Section III, Item 1,and Fill Hose Assemblies removed, refer toAppendix Bparagraph 4.13.2.Material/PartsPressure Gauge and Fill Assembly removed,refer to paragraph 4.13.3.Reservoir (TM 10-4320-303-23p)Strainer removed, refer to paragraph 4.13.4.Toolbox (TM 10-4320-303-23P)Water Meter and Gear Box Assembly removed,Lock washers (TM 10-4320-303-23P)refer to paragraph 4.13.5.EquipmentConditionsManifold Assembly removed, refer toparagraph 4.13.7.Hypochlorination Unit, Model 1955-1removed, refer to paragraph 4.13.1.GeneralSafetyInstructionsDo not work on equipment without followingstandard shop safety precautions.4.13.8.1 Removal. Placing the frame assembly (Figure 4-21, 1) in the equipment conditions specified abovewill remove the frame assembly (1) from the hypochlorination unit.4.13.8.2 Disassembly.a. Remove chlorine reservoir (1) from frame (2).b. Open top of tool box (3).c. Remove four nuts (4), lock washers (5), and screws (6). Discard lock washers (5).d. Remove tool box (3) from frame (2).4.13.8.3 Inspection.a. Inspect chlorine reservoir (1) for cracks, holes, or damage.b. Inspect frame (2) for cracks, bends, or separation of welds.c. Inspect tool box (3) for smooth operation of top, corrosion, cracks, holes, or damage.d. Inspect mounting hardware for damage.4.13.8.4 Repair.a. Replace damaged or defective chlorine reservoir (1) or tool box (3).b. Notify direct support if frame (2) is damaged or defective.4-53
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
