TM 10-4320-345-13
Section I. REPAIR PARTS AND SPECIAL TOOLS LIST
4-1. COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE), CTA 50-970 or CTA 8-100, applicable to your unit.
4-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
Refer to the Maintenance Allocation Chart contained in Appendix B for maintenance tasks authorized at unit
level maintenance and the TMDE and support equipment required to perform these tasks. No special tools are
required to maintain the Tactical Water Distribution System.
4-3. REPAIR PARTS.
Repair parts are listed and illustrated in the repair parts and special tools list, TM 10-4320-345-24P, covering
unit, direct support, and general support maintenance of this equipment.
Section II. SERVICE UPON RECEIPT
4-4. SITING
a.
Transport. The water system is designed to be packaged and shipped inside four TRICONs, 64 flaking
boxes and various crating supplied with the system. Transport the water system only on equipment
compatible with TRICON transport requirements (TM55-8145-200-13&P).
b.
Site Selection. When selecting a site for installation of the water system, consider the overall operating
area Siting must include access to the water source, adequate space to set up four 600 gpm pumping
stations, two water storage and distribution points and associated hoseline to connect the water system
to large water distribution centers (maximum hoseline length is 10 miles Site should be level and
provide good water drainage away from system components. If possible, site should slope down hill
from water source to water dispensing points.
4-5. SHELTER REQUIREMENTS
The water system does not require special sheltering during normal operation. Heated shelters may be
required when operating in extremely cold conditions (below 32°F) . Store unused water system components in
the TRICONs and packing crates to prevent damage and minimize routine maintenance.
4-2
