TM 10-4320-345-13
2-11. ASSEMBLY ANI) PREPIARATION FOR USE - cont.
Install Swivels Refer to figure 2-20.
WARNING
To prevent system contamination, protect hose ends and coupling clamps
from sand, dirt and debris.
CAUTION
To prevent damage to the equipment, a swivel joint must be installed
every 1,000 feet to prevent damage caused by twisting and rolling of hose
when system is pressurized.
NOTES
·
Remove caps or packaging material from ends of hose as required.
·
One coupling clamp is supplied on trailing end of hose, the other is
supplied with the swivel joint.
(19)
Remove coupling clamps (4) from leading ends of hoses (1, 6, 8, and I 0) in flaking boxes 1
through 4.
(20)
Connect swivel (3) to leading end of hose (1) in flaking box No 4 with coupling clamp (5)
Connect other end of swivel to trailing end of hose (2) in flaking box No 3 with coupling
clamp (4).
(21)
Connect swivel (3) to leading end of hose (6) in flaking box No 3 with coupling clamp (5)
Connect other end of swivel to trailing end of hose (7) in flaking box No 2 with coupling
clamp (4).
(22)
Connect swivel (3) to leading end of hose (8) in flaking box No 2 with coupling clamp (5)
Connect other end of swivel to trailing end of hose (9) In flaking box No. 1 with coupling
clamp (4).
(23)
Connect swivel (3) to trailing end of hose (11) with coupling clamp (4).
2-46
