TM 10-4610-234-13
2.11 ASSEMBLY AND PREPARATION FOR USE - continued
Quick Disconnect Couplings
b. 125 GPM Pump Connect Kit Assembly (water source). Two 125 GPM pump connection kits are
supplied with this system. Assemble the 125 GPM pump connection kit located at the water source
(pipeline) as follows:
To prevent contamination of drinking water, make sure water tank el-
bows are capped and plugged when system hoses are not connected
to tank.
CAUTION Before connecting hoses, make sure suction (rigid) hoses
only are installed between pump and water source. If this is not done,
damage to hoses and pump can occur,
NOTE
• Install all gate valves with hand wheel in upright position and valve fully
closed.
—
• Suction hoses are noncollapsible and discharge hoses are collapsible.
2-20
