TM 10-4610-237-12
2.12 PREPARATION FOR MOVEMENT - Continued.
(12) Drain and allow components to dry.
(13) Install caps and plugs on component couplings (para. 2.7c).
(14)
Roll up all discharge hoses and secure with tape.
(15) Prepare 125 gpm pump (6) for movement. Refer to the applicable TM.
e.
Disassemble Single Tank Connection Kit. Refer to Figure 2-14.
WARNING
To prevent contamination of water system components, keep dirt, mud, sand, and debris from
entering open couplings during disassembly. Make sure protective caps and plugs are installed
after components are disassembled.
(1)
Disconnect 10-foot discharge hose (10) from female (inlet) coupling on hypochlorination unit (12).
(2)
Disconnect discharge hose (10) from tee and dual gate valve assembly (9).
(3)
Disconnect tee and dual gate valve assembly (9) from 20-foot discharge hose (8).
(4)
Disconnect discharge hose (8) from 20-foot discharge hose (7).
(5)
Disconnect discharge hose (7) from 20-foot discharge hose (5).
(6)
Disconnect discharge hose (5) from female filler elbow (6) on water tank (11).
(7)
Disconnect 10-foot suction hose (4) from water source.
(8)
Disconnect suction hose (4) from tee and dual gate valve assembly (3).
(9)
Disconnect tee and dual gate valve assembly (3) from 20-foot suction hose (1).
(10) Disconnect suction hose (1) from male elbow (2) on water tank (11).
(11) Drain and allow components to dry.
(12) Install caps and plugs on component couplings (para. 2.7c).
(13) Roll up all discharge hoses and secure with tape.
(14) Prepare hypochlorination unit (12) for movement. Refer to applicable TM.
(15) Prepare water tank (11) for movement. Refer to applicable TM.
2-37
