TM 10-4610-242-13
2-10. ASSEMBLY AND PREPARATION FOR USE cont.
n.
Assemble Bag Filler Connection Kit Refer to figure 2-21
WARNING
To prevent contamination of drinking water, make sure protective caps and plugs are installed
when components are not in use. Do not remove caps and plugs from components until
couplings are ready to be connected.
NOTE
Install all gate valves with hand wheel in upright position and valve fully closed.
(1)
Connect 4 inch x 20 foot discharge hose (2) to tee (1) (from hose nozzle connection kit no. 4).
(2)
Connect 4 inch x 20 foot discharge hose (3) to 4 inch x 20 foot discharge hose (2).
(3)
Connect tee (5) to 4 inch x 20 foot discharge hose (3).
(4)
Connect adapter (4 inch female x 2 inch male (6) to tee (5).
(5)
Connect 2 inch x 20 foot discharge hose (7) to adapter (6).
(6)
Connect wye (8) to 2 inch x 20 foot discharge hose (7).
(7)
Connect 2 inch x 20 foot discharge hose (9) to wye (8).
NOTE
The 2 inch gate valves used in this connection kit have a 2 inch female coupling on one end and a
1-1/2 inch male coupling on the other.
(8)
Connect 2 inch gate valve (10) to 2 inch x 20 foot discharge hose (9).
(9)
Connect 11/2 inch x 25 foot discharge hose (11) to 2 inch gate valve (10).
(10)
Connect 2 inch x 20 foot discharge hose (12) to wye (8).
(11)
Connect wye (13) to 2 inch x 20 foot discharge hose (12).
(12)
Connect 2 inch gate valve (14) to wye (13).
(13)
Connect 1-1/2 inch x 25 foot discharge hose (15) to 2 inch gate valve (14).
(14)
Connect 2 inch gate valve (16) to wye (13).
(15)
Connect 1-1/2 inch x 25 foot discharge hose (17) to 2 inch gate valve (16).
(16)
Install cap (4) on unused male coupling on tee (5).
2-56
