TM 10-4610-243-13
2-15. PREPARATION FOR MOVEMENT-cont.
(4)
Disconnect regulator (5) from 1 inch x 10 foot discharge hose (4).
(5)
Disconnect two I inch x 10 foot discharge hoses (3 and 4) from adapter (2).
(6) Disconnect adapter (1-½ inch female x 1 inch male) (2) from 1-½ inch x 25 foot discharge hose (1) (from
bag filler connection kit).
(7)
Repeat steps 1 through 6 for remaining hose and nozzle kits.
(8)
Drain and allow components to dry.
(9)
Install caps and plugs o0 couplings (para 2-10c).
c.
Disassemble Bag Filler Connection Kits. Refer to figure 2-27.
WARNING
To prevent contamination of water system components, keep dirt mud, sand, and
debris from entering open couplings during disassembly. Make sure protective
caps and plugs are installed after components are disassembled.
To prevent injury to personnel, all water pumps must be shutdown and water
pressure relieved from discharge hoses before disconnecting couplings.
(1)
Disconnect 1-½ inch x 25 foot discharge hose (17) from 2 inch gate valve (16).
(2)
Disconnect 2 inch gate valve (16) from wye (13).
(3)
Disconnect 1-½ inch x 25 foot discharge hose (15) from 2 inch gate valve (14).
(4)
Disconnect 2 inch gate valve (14) from wye (13).
(5)
Disconnect wye (13) from 2 inch x 20 foot discharge hose (12).
(6)
Disconnect 2 inch x 20 foot discharge hose (12) from wye (8).
(7)
Disconnect 1-½ inch x 25 foot discharge hose 11) from 2 inch gate valve (10).
(8)
Disconnect 2 inch gate valve (10) from 2 inch x 20 foot discharge hose (9).
(9)
Disconnect 2 inch x 20 foot discharge hose (9) from wyc (8).
(10)
Disconnect wye (8) from 2 inch x 20 foot discharge hose (7).
(11)
Disconnect 2 inch x 20 foot discharge hose (7) from adapter (6).
(12)
Disconnect adapter (4 inch female x 2 inch male) (6) from tee (5).
(13)
Disconnect tee (4) from 4 inch x 20 foot discharge hose (3).
2-70
