TM 10-5430-240-13&P
0005 00
0005 00-6
Installation of the Tank on the Trailer Bed
CAUTION
Do not attach handles to a mechanical pulling device or damage to the tank will
occur. Only walk on tank wearing soft soled shoes wiped clean of all abrasive
materials.
1. Using a suitable lifting device, carefully attach to the sling by the lift straps and place the tank on the
semi-trailer in such a manner that the tank will unroll towards the rear of the trailer. The tank ends
should be near or touching the trailer bulkhead.
2. Remove the straps from the buckles on the sling assembly, unroll and unfold the tank over the tie-
down straps. Visually inspect the tank while unrolling. Position the tank so that when it is full, the ends
of the sidewalls will not rub against the forward bulkhead or hang over the sides of the trailer. Remove
the sling assembly from under the tank and place it in the trailer storage compartment.
3. Inspect the tank body for any punctures or tears. Inspect the fittings and components for evidence of
damage or missing bolts or gaskets.
Correction of deficiencies
Correct deficiencies found during the initial inspection as follows:
a. Deficiencies within the scope of unit maintenance should be corrected before the tank is placed
into service. Tears or punctures in the tank walls may be temporarily repaired by following the
instructions in WP 0006 00.
b. Serious deficiencies, or deficiencies beyond the scope of this manual, should be brought to the
attention of your supervisor. Do not attempt unauthorized repairs.
OPERATING INSTRUCTIONS ON DECALS AND INSTRUCTION PLATES
Instruction plates are used on the 3,000 gallon and 5,000 gallon tanks to advise the operator of proper
operating procedures. Stencils provide additional operating information and cautions to be observed
during use of equipment. The following illustrations show the typical decals provided on the collapsible
fabric water tanks, and identify their location on the unit.
