Installation - TM-10-6640-229-13P

General information - TM-10-6640-229-13P_5

TM-10-6640-229-13P Precision General Purpose Water Baths Model TS-66518 AW-9 NSN 6640-00-403-0420 Manual
Page Navigation
3

Precisionâ Instruction Manual Installation Location: The most uniform operating conditions and results will be obtained by placing the bath in an area remote from drafts, ventilating outlets, radiators, and other rapidly changing ambient conditions. Cleaning: The interior of the bath, shelf platform, and cover should be washed with a mild detergent solution and rinsed with distilled water. Electrical Connections: Important (Please Read Carefully.) CAUTION: DO NOT connect bath to power supply unless bath is filled with at least 1" of water and the line switch is in the "Off" position. This will prevent the heater from burning out. WARNING: For personal safety, this apparatus must be properly grounded. The power cord of this instrument is equipped with a three-prong (grounding) plug which mates with a standard three prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this apparatus. The user should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded. Where a two-prong receptacle is encountered, it is the personal responsibility and obligation of the user to have it replaced with a properly grounded three-prong wall receptacle. WARNING:DO NOT, under any circumstance, cut or remove the third (ground) prong from the power cord. DO NOT use a two- prong adapter plug. Determine the total amount of current presently being used by other apparatus connected to the circuit that will be used for this unit. It is critical that the added current demand and other equipment on the circuit not exceed the rating of the fuse or circuit breaker in use. CAUTION: Be sure the power supply is of the same voltage as specified on the nameplate. Operation Before filling, check line switch to be sure it is in the "Off" position. Adjust the diffuser pan legs so that the pan will be at the desired depth when the water level is within 1-1/2" of top. NOTE: Legs are not supplied on the Model 180. Fill bath with distilled water, making allowance for displacement by the sample(s) to be immersed, and for expansion of the media upon reaching operating temperature. The maximum liquid level should be 1-1/2" from top surface of the bath after object(s) are immersed. NOTE: Distilled water is recommended. Distilled water will not cause corrosion to the bath chamber, and cleaning of the bath will be less fre- quent. -3-

Privacy Statement
Press Release
Contact