TM5-3820-256-10e.Insert the pump leads through the hole in bottom of panel.f.Connect the leads as follows: black to T1, red to T2, yellow to T3, and green to ground.g.Strip away approximately six inches of outer insulation from power source cable and strip awayapproximately 3/4 inch of insulation from each lead.h.Insert the power source cable through hole in side of panel and connect leads at Line 1, Line 2, Line 3 andGround.i .Close panel door and turn door locking screws to engage door locks.Figure 2-53. Starter Panel Installation2-119
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
