TM5-3820-256-10
(3)
Rotary Table. Ensure that rotary table driveshaft is free from dirt and debris, then retract rotary table.
(4)
Hydraulic jacks.
(a)
Check the pressure in the truck tires; inflate any that are low.
(b)
Operate the hydraulic jack controls to raise the jacks evenly, returning the weight of the rig to the
truck's tires. Release the jacks to the center (neutral) position when each jack is fully raised.
CAUTION
The hydraulic jacks may "creep" down if the safety links are not snapped into place after the jacks are
fully raised.
(c)
Snap each safety link in place on each hydraulic jack so that the jacks are secured in the raised
position.
(d)
If supporting timbers were placed under the hydraulic jacks, remove and stow them or dispose of them
properly.
b. Rig Tender.
(1)
Store all drill pipe and drill collars.
(2)
Disconnect and store all water discharge hoses and suction hoses and strainer.
(3)
Store the propane tank and heating torch, if removed, (4) Store the fuel nozzle and hose, if removed.
(5)
Position the crane in its travel position and secure it. Return the remote control pendant to its storage box.
(6)
Close all storage compartments and secure.
c. Well Completion Equipment. Store the well probe, instruments, test set, well sounder, bailer, and wires and
cables in their appropriate storage compartments.
Change 1 2-129/(2-130 blank)
