o.Install 2 seals (1 3) in grooves provided on either side of rotor assembly (15). Place rotor assembly ontomanifold plate while at the same time engaging spline in rotor with drive link (12). Make certain that thedeep groove in the rotor goes down toward the manifold plate and the shallow groove faces up. Alignbolt holes.p.Drop pin (16) into the drive link (12).q.Place pressure plate (17) onto rotor assembly (15) taking extreme care to insure that pin (16) engageswith the 1/8" center hole in pressure plate (17). (It is very important that pin engages in hole asimproper assembly here will cause rapid motor failure.) Turn pressure plate to align bolt holes.r.Install seal (13) into groove provided in end cover (18).s.Place end cover (18) onto pressure plate (17) and align bolt holes.t.Insert seven bolts (19) and torque to 50 foot-pounds. Remove motor from vise and place on workbench, shaft up.u. Install dust seal (1) top flush with housing pilot face.3-8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
