q. Place eight springs (66) over eight roll pins on retainer plate (60). Install retainer plate and secure to clutchusing four capscrews (31). Firmly seat the retainer ring (62) into drum shaft groove.r. Set the shifter assembly (1) so that the screw heads engage the external groove in the locking ring (7). Push theclutch housing (14) onto the drum shaft and latch the shifter assembly in the engaged "IN" position. Insert thetwo capscrews (40).s. Attach mounting angles (2) to winch assembly. Use hardware shown in parts list. Remove plug (55 & 53) fromtop to gear housing. Pour 3-3/4 pints of S. A. E. 140 oil into hole and replace plugs. Plug (56) can be removedto check oil level.t. Check the action of the clutch by shifting and freespooling the winch drum several times.u. The shift pattern plate on top of the clutch housing is adjusted at the factory to provide reliable shifting of theclutch. If the plate should loosen or be removed, you must readjust the plate. Shift the handle to disengage theclutch and hold against the internal stop. With the latching pin in the "OUT" slots, push the shift pattern platetoward the cable drum. Unsnap plastic lever cover from pattern plate. Tighten the four capscrews which holdthe plate to housing. Snap lever cover back into place around the pattern plate.6-9 WINCH DRIVE MOTOR6-9.1 Maintenance. The winch drive motor is the same type as water system hydraulic motor. Refer to paragraph 3-4for maintenance procedures.6-13/(6-14 Blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
