TM 5-3820-256-24P-1(8) In the Special Tools List Section, the basis of issue (BOI) appears as the last line(s) in the entry for each specialtool, special TMDE, and other special support equipment. When density of equipment supported exceeds density spreadindicated in the basis of issue, the total authorization is increased proportionately.(9) The statement “END OF FIGURE" appears just below the last item description in Column (5) for a given figurein both Section II and Section III.(10) The indenture, shown as dots appearing before the repair part, indicates that the item is a repair part of thenext higher assembly.f. QTY (Column (6)). The QTY (quantity per figure) column indicates the quantity of the item used in the breakoutshown on the illustration figure, which is prepared for a functional group, subfunctional group, or an assembly. A "V"appearing in the column in lieu of a quantity indicates that the quantity is variable and may vary from application toapplication.4. EXPLANATIONOFINDEXFORMATANDCOWMNS(SECTIONIV).a. NATIONAL STOCK NUMBER (NSN) INDEX.(1) STOCK NUMBER Column. This column lists the NSN in national item identification number (NIIN) sequence.The NIIN consists of the last nine digits of the NSN, i.e.NSN5305-01-574-1467NIINWhen using this column to locate an item, ignore the first four digits of the NSN. However, the complete NSNshould be used when ordering items by stock number.(2) FIG. Column. This column lists the number of the figure where the item is identified/located. The figures are innumerical order in Section II and Section III.(3)ITEM Column. The item number identifies the item associated with the figure listed in the adjacent FIG.column. This item is also identified by the NSN listed on the same line.b. PART NUMBER INDE. Part numbers in this index are listed by part number in ascending alphanumeric sequence(i.e., vertical arrangement of letter and number combination which places the first letter or digit of each group in order Athrough Z, followed by the numbers 0 through 9 and each following letter or digit in like order).(1) CAGEC column. The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric code used toidentify the manufacturer, distributor, or Government agency, etc., that supplies the item.(2) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm, corporation,or Government activity), which controls the design and characteristics of the items by means of its engineering drawings,specifications standards, and inspection requirements to identify an item or range of items.(3) STOCK NUMBER column. This column lists the NSN for the associated part number and manufactureridentified in the PART NUMBER and CAGEC columns to the left.(4) FIG. Column. This column lists the number of the figure where the item is identified/located in Sections II andIII.5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
