TM 5-3825-226-24
TIMING GEAR COVER AND OIL PUMP
8.
Loosen the clamp and disconnect hose (12)
from the timing gear cover.
9.
Remove water temperature sending unit (11)
from the timing gear cover.
10.
Remove the two bolts, connector (10) and the
gasket.
11.
Remove the two bolts that hold front support
(14) to the tractor frame.
12.
With tooling (B) lift the engine enough to take
the weight off of support (14).
13.
Remove four bolts (13) and support (14).
14.
Make a replacement of bolts (15) and (16) on
the top of the timing gear cover with two 7/16" x
14 NC forged eyebolts.
15.
Remove the bolt that holds clip (18) for the fuel
bleed lines.
16.
Fasten a hoist to the timing gear cover.
17.
Remove the bolts and one nut that hold the
timing gear cover (17). Put identification on the
bolts as to their location for correct installation.
18.
Remove the bolt used to make an alignment of
the timing gears.
CAUTION:
Do
not
cause
damage
to
the
crankshaft front seal when the timing
gear cover is removed and installed.
19.
Pull timing gear cover (17) from the dowels on
the cylinder block to remove the water sleeves
from the cylinder heads. Remove the timing
gear cover and oil pump. The weight of the
timing gear cover and oil pump is 130 lb. (59
kg).
3-119
