TM 5-3825-226-24 TIMING GEAR COVER AND OIL PUMP INSTALL TIMING GEAR COVER AND OIL PUMP Tools Needed A B C FT1321 Support Beam 1 1H5514 Bolt (5/16"-18 NC x 1 5/8 in.  long) 4 8S7630 Stand 1 8S7611 Tube 1 BS7615 Pin 2 8S7625 Collar 1 8S7650 Cylinder 1 5P3100 Pump Group 1 5P7308 Water Sleeve Tool 1 1. Clean the contact surfaces of the cylinder block and  timing  gear  cover.    Install  the  timing  gear cover   gasket   on   the   cylinder   block.      Cut   the gasket even with the cylinder block pan rail. NOTE: Make    sure    the    water    sleeves    are installed   in   the   timing   gear   cover. Put oil on the seals. 2. Install  two  7/16"-14  NC  forged  eyebolts  in  the timing gear cover.  Fasten a hoist and put timing gear  cover  and  the  oil  pump  in  position  on  the engine.      Make   sure   the   oil   pump   gear   and crankshaft gear are in alignment. 3. If   necessary   use   tool   (C)   to   push   the   water sleeves into the cylinder heads. 4. Install the bolts and nut that hold the timing gear cover. 5. Remove  the  hoist  and  make  a  replacement  of eyebolts (1) with the original bolts. 6. Install the clip to hold the fuel bleed lines. 7. Put the front support in position and install bolts (5)  and  the  washers  that  hold  it  to  the  timing gear cover. 8. Put mount assemblies (7) in position and install bolts  (6)  and  the  washers.    Lower  the  engine with tooling (A) and (B) and tighten bolts (6). 9. Remove tooling (A) and (B). 10. Install the gasket and connector (2). 11. Install water temperature sending unit (3). 12. Connect hose (4) to the timing gear cover. 3-120