TM 5-3825-226-24
FINAL DRIVES
DISASSEMBLE FINAL DRIVES
start by:
a) remove final drives
1.
Remove shafts (1) from the final drive
carrier.
2.
Remove the retaining rings from the
shafts.
3.
Remove gears (2), the six steel washers,
the six bronze washers and the six
bearings from gears (2).
ASSEMBLE FINAL DRIVES
1.
Install bearings (3) and (4) in gear (9).
2.
Install ring (8) on shaft (7).
3.
Hold washers (1), (2), (5) and (6) in
position on gear (9).
NOTE:
Steel washers (2) and (5) must be assembled next to
gear (9).
4.
Install gear (9), the bearings and the
washers in final drive carrier (10).
5.
Install shaft (7) in final drive carrier (10) to
hold gear (9) in position.
NOTE
Make sure the flat surface of shaft (7)
is toward the outside of final drive
carrier (10) so the cover assembly
can be installed. Do Steps I through
5 for the other two gears in final
drive carrier.
end by:
a) install final drives
3-148
