TM 5-3825-226-24
TORQUE CONVERTER
16.
Put clean oil on the ring on the shaft.
Install carrier (16) on the shaft as shown.
17.
Install the bearing in gear(17) with tool (B)
and an arbor press. Install the bearing
until it is .32 in. (8.13 mm) below the
machined surface (with threaded holes) of
the gear.
18.
Put wheel assembly (18) in position over
gear (17). Install the bolts and plates that
hold the unit together. Tighten the bolts
to a torque of 20 ± I lb.ft. (25 ± 1 N.m).
19.
Install the wheel assembly over the
carrier.
3-169
