TM 5-3825-226-24
TORQUE CONVERTER
24.
Install two 5/16"-18 NC guide pins 6 in.
(15.2 cm) long in the rotating housing.
Put rotating housing (23) in position over
the turbine. Install five of the twenty-four
bolts to hold the housing in position.
Tighten the five bolts to a torque of 20 ±
1 lb.ft. (25 ± I N.m).
25.
Install ring (24) in bearing (25). Install the
bearing in the rotating housing as shown.
26.
Heat inner race (26) to a maximum
temperature of 275°F (135°C) and install
it on the end of the shaft as shown.
27.
Install pin (29) in the end of the shaft.
Install retainer (28) and bolt (27). Tighten
the bolt to a torque of 81 ± 4 Ib.ft. (111 ±
5 N.m).
3-171
