TM 5-3825-226-24
TRANSFER GEARS (INPUT)
(1) Torque for bolt that holds flange
to output gear ............................ 80 ± 5 lb. ft. (109 ± 7 N•m)
(2) Put a small amount of the lubricant being sealed on lip of
seal. Install
the seal with lip toward the bearing cup.
(3) Torque for the nut ............... 150 ± 10 lb. ft. (204 ± 14 N•m)
TRANSFER GEARS (OUTPUT)
NOTE: Install idler gear (4) with bearing assembly and idler
shaft (5) into the case assembly and tighten bolts (6) before
checking end clearance of input gear (3) and output shaft (11).
(2)
Add or remove shims (1) to get end clearance
of input shaft of .......... 003 to .005 in. (0.08 to 0.13 mm)
(7)
End clearance after new bearing is assembled
(no adjustment possible) .003 to 0.013 in. (0.08 to 0.33
mm)
(9)
Add or remove shims (8) to get end clearance of bearings
on output shaft of .......003 to .005 in. (0.08 to 0.13 mm)
(10)
Torque for bolt that holds yoke to
the output shaft ................... 80 ± 5 lb. ft. (109 ± 7 N m)
(12)
Put 7M7260 Liquid Gasket in bore of the cages for the
seals and let dry before installing seals. Do not put Liquid
Gasket on case of the seals. Put a small amount of the
lubricant being sealed on lip of the seals. Install the seals
with lip toward the bearing cup.
1-45
