TM 5-3825-226-24
TRANSMISSION AND SCAVENGE PUMP
Rotation is counterclockwise when seen from the drive
gear. For bench test use SAE 10W oil at 120° F (49°C).
(1) Pressure section:
Output ......................... 24.3 U.S. gpm (91.97 litre/min)
with pump at ................................ ................. 2855 rpm
at a pressure of ......... 310 psi (21.8 kg/cm2) (2137 kPa)
(2) Scavenge section:
Output ........................... 9.7 U.S. gpm (36.73 litre/min)
with pump at ................................ ................. 2855 rpm
at a pressure of ............... 60 psi (4.2 kg/cm2) (414 kPa)
(3) Torque for bolts ................... 36 ± 2 lb. ft. (49 ± 3 N.m)
(4) Diameter of shafts ............................. 88 in. (22.4 mm)
TRANSMISSION HYDRAULIC CONTROLS
(8S3437)
(1) Torque for the bolts
(12 point head) .................... 22 ± 3 lb. ft. (30 ± 4 N.m)
(2) Torque for the bolts
(6 point head) ...................... 35 ± 5 lb. ft. (48 ± 7 N.m)
(3) Torque for the bolts (two) that hold control levers to the
shaft ................................ ... 35 ± 5 lb. ft. (48 ± 7 N.m)
NOTE: Put 7M7260 Liquid Gasket on
bore surface in transmission case for
the lip-type seals and let dry. Do not let
Liquid Gasket get on the case of the lip-
type seals. Put a small amount of the
lubricant being sealed on the lip of the
seals before installation.
1-41
