TM 5-3825-226-24
6.
Install seal assembly (6) and wear ring (7) on
the piston.
7.
Put crown (8), head (9) and piston (10) on the
cylinder rod.
8.
Put 2P2506 Thread Lubricant on the threads of
the bolt that hold piston (10) in position on the
rod. Install the bolt and washer that hold the
piston in position.
9.
Put tooling (F) in position. Use tooling (F) to
tighten the bolt for the ejector and steering
cylinders to a torque of 1080 ± 108 N•m (800 ±
80 Ib. ft.). Tighten the bowl lift cylinder bolts to
a torque of 1125 ± 100 N•m (830 ± 75 Ib. ft.).
Tighten the floor cylinder bolt to a torque of
2580 ± 258 N•m (1910 ± 190 Ib. ft.).
10.
Remove tooling (F).
11.
Install rod assembly (11) in the cylinder.
Remove support (12) from under the cylinder
rod.
12.
Put clean grease on the threads on the outside
diameter of the cylinder and on the threads on
the inside diameter of crown (8).
3-361
