TM 5-3825-226-24
CRANKSHAFT
INSTALLING FRONT OIL SEAL
1. Bolt. 2. Washer. A. 5P4194 Installer Assembly.
3.
Put engine oil on the lip of the seal before
installing the pulley.
CRANKSHAFT PULLEY REMOVAL
1.
Remove pulley retaining bolt and washer.
2.
Remove the pulley using a 5F7465 Puller
Assembly, 8B7560 Step Plate, two 5M2894
Washers, and two S1571 Bolts.
PULLEY REMOVAL
(Typical Example)
CRANKSHAFT PULLEY INSTALLATION
INSTALLING PULLEY
1. Crossbar. 2. Washer. 3. Nut. 4. Screw.
1.
Lubricate lip of crankshaft front oil seal and the
sealing surface of crankshaft pulley with engine
oil (SAE 30).
2.
To install pulley, start pulley on crankshaft. Put
screw (4) from the 8B7548 Push Puller into the
crankshaft until it bottoms out. Put crossbar (1)
from the 8B7548 Push Puller onto screw (4).
Install washer (2) and nut (3) to on screw (4).
Hold screw (4) and turn nut (3) to press pulley
onto crankshaft. When installed, the pulley hub
will contact the crankshaft gear.
3.
Remove the tool setup. Install the pulley
retaining bolt and washer. Tighten the pulley
retaining bolt to 460 ± 60 lb. ft. (624 ± 80 N
m).
3-387
