TM 5-3825-229-14&P6-13. CAMSHAFT (cont)c.Installation.(1)Install key (5) in slot in camshaft (6). Drive key into slot with a leather hammer.(2) Lubricate retainer (4) with oil (OE/HDO) and slide retainer on camshaft (6).(3) Lubricate gear mounting surface on end of camshaft with oil (OE/HDO).NOTETiming marks on camshaft gear (1) must face out (away from camshaft) when installing gear on camshaft.(4) Install the camshaft (6) and camshaft gear (1) in a press. Support the camshaft on the No. 1 bearing journal andpress camshaft gear on camshaft until gear contacts shoulder on camshaft.(5) Recheck clearance between retainer (4) and gear (1). Refer to 6-13. b. (4) above.(6) Install camshaft (6), with attached gear (1), in crankcase. Check to make sure timing marks on camshaft gearalign with timing marks on idler gear. Refer to para. 6-8.(7) Install two washers (3) and screws (2). Tighten screws to a torque of 17 Ib-ft (23 Nm) (wet).(8) Check and verify gear backlash. Refer to 6-13. a. (1) above.(9) Check end play of crankshaft gear. Attach a dial indicator to the crankcase with indicator contacting gear. Pullcamshaft gear and shift in and out of crankcase. End play should be 0.004 to 0.020 in. (0.10-0.50 mm). If endplay is excess replace retainer (4).6-38
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
