Figure G-1. Hydraulic Hoses

CROSS-REFERENCE INDEXES -FIGURE AND ITEM NUMBER INDEX (cont) - TM-5-3895-370-14P_1351

Table G-1. Hydraulic Hose Assemblies and Components.

TM-5-3895-370-14P Spreader Aggregate: Towed; 3 Ft Spread FF-8 (NSN 3895-01-329-5096) Manual
Page Navigation
1340

TM 5-3895-370-14&P APPENDIX G MANUFACTURED ITEMS LIST G-1. INTRODUCTION. This appendix includes complete instructions for manufacturing or fabricating items needed for Unit, Direct, and General Support Maintenance. A part number index in alphanumeric order is provided for cross-referencing the part number of the item to be manufactured to the figure which covers fabrication criteria. All bulk materials needed for manufacture of an item are listed by part number or specification number in a tabular list on the illustration. G-2. HYDRAULIC HOSE FABRICATION. NOTES: NOTE TABLE G-2 LISTS SEVERAL CONFIGURATIONS OF HYDRAULIC HOSES. THE FOLLOWING FABRICATION INSTRUCTIONS APPLY TO ALL OF THE LISTED CONFIGURATIONS. 1. OBTAIN ALL COMPONENTS REQUIRED TO FABRICATE DESIRED HOSE ASSEMBLY (TABLE G-2). 2. USE A FINE TOOTHED HACKSAW OR SUITABLE CUTTING DEVICE, AND CUT HOSE TO INDICATED LENGTH. 3. SLIDE FERRULES C ON HOSE AS NECESSARY. 4. PLACE FITTING A IN VISE. 5. SLIDE AND TURN HOSE ON FITTING A UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN. 6. PLACE FITTING B IN VISE. 7. SLIDE AND TURN HOSE ON FITTING B UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN. 8. SLIDE ONE EACH FERRULE TO END OF HOSE UNTIL THEY ARE AGAINST FITTINGS A AND B. 9. CRIMP FERRULES TO HOSE. Figure G-1. Hydraulic Hoses. G-1

Privacy Statement
Press Release
Contact