TM 5-3895-370-14&P
WARNING
The bituminous system is under
extreme
pressure
and
high
temperature. Ensure locking pins are
secured with safety pins on hand
spray wand and hose assembly or
injury to personnel may result.
(8)
Remove dust cap (15) from valve #6 (6).
Connect hose (11) to valve #6.
(9)
Move pump transmission control lever (16)
forward (FWD) and run system at 50-100
GPM. Increase RPM to 2100.
(10)
Place valves in the following positions
(Hand spray, Figure 2-2, Sheet 3): (a)
Place valve #1 (1) midway between bar
and tank position.
(b)
Open valve #2 (2).
(c)
Close valves #3 (3), #4 (4), and #5
(5).
(d)
Open valve #6 (6).
(11)
Open secondary valve (14) on wand (9),
as shown.
WARNING
The bituminous system is under
extreme
pressure
and
high
temperature. Never point hand spray
wand at personnel or severe injury or
death may occur.
(12)
Grasp hand spray wand (9) firmly and
point towards ground and away from
personnel.
(13)
Slowly open primary valve (13) until
material begins to spray.
(14)
When
spraying
is
completed,
close
primary and secondary valves (13 and 14)
and return engine RPM to 1200.
2-61
