TM 5-5430-212-13Pa. Inspect(1)Inspect each of the top clamps (4, Fig. C-1 or C-1A) for burrs, sharp edges and cracks.(2)Inspect each of the bottom clamps (5, Fig. C-1 or C-1A) for burrs, sharp edges, cracks anddamaged threads.(3)Check handles (13, Fig. C-1 or C-1A) for burrs, sharp edges and cracks.(4)Check all bolts for proper torque of 70 + 5 ft. lbs.b.RepairRepair any damage to the end clamp assembly by removing and repairing only one assembly at a time. The rightand left, top and bottom end clamps and handles must remain in the original location.c.ReplacementofIndividualClampAssembly(Fig.C-1orC-1A)(1)Remove the bolt (12) and flat washer (11) from the top (6) and bottom (7) clamp assembly.(2)Remove the assembly from the tank.(3)Remove all burrs and sharp edges from the clamps.(4)If the clamps are cracked or the bottom clamp threads are damaged, replace.(5)Place the top (6) and bottom (7) clamps on the tank.(6)Place the ½-13 (12) hex head bolt thru the flat washer (11), top clamp (6), and thread it into thebottom clamp (7).(7)Torque to 70 + 5 ft. lbs.d.ReplaceHandleGripAssemblies(Fig.C-1orC-1A)(1)Remove the three bolts (12) and flat washers (11) from the handle assemblies. The handleassembly consists of one handle (13) and three bottom clamps (7).(2)Remove the handle (13) and bottom clamps (7) from the tank.(3)Remove all burrs and sharp edges from the handle and clamps.(4)If the handle is cracked or the bottom clamp is cracked or contains damaged threads, replace.Change 3 3-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
