d)
Turn on main power switches.
e)
Lower outboard or outdrive.
f)
Check that gearshift is in neutral.
g)
Start engine in accordance with the procedure in the manual.
h)
Observe oil pressure gauges and voltmeters for normal readings (see manual).
i)
Check to ensure all water, fuel, lubricating oil and exhaust cooling water is flowing where applicable.
j)
Observe exhaust overboard to ensure that exhaust cooling water is flowing where applicable.
k)
Observe temperature gauges for normal readings.
l)
Start up generators in the same manner as main engines.
m) Apply loads to generator one at a time in accordance with the manual. In general, it is better to apply a few
small loads before switching on a large load such as an air conditioner.
n)
Light off any additional equipment such as radar, depth finder, etc. before leaving the dock. This will prevent
your attention from being divided as you get underway.
o)
Make ready an anchor with the end of the anchor line secured around a bitt or cleat.
4.2
NORMAL OPERATION
a)
Bring the engines to idle and shift to the ahead position for a moment and back to neutral. Observe that the
gear shifts and the boat goes in the ahead direction.
b)
Repeat a) going astern.
CAUTION
MANEUVER AT IDLE SPEED
c)
Cast off lines and move away from the dock by shoving off.
12
