1.8
The pipework, three-way valves, condensate drain, C02 system piping, and smoke accumulators are covered in the
C02 system manual.
1.9
Figure 1-1 shows the basic system and part numbers for each item.
1.10
Figure 1-2 shows the dimensions and mounting details of the smoke detector cabinet assembly (maximum 24
lines). Slave detection cabinets have identical dimensions and requirements, and increase capacity to 48 lines.
1.11
This cabinet must be mounted upright on a bulkhead not subject to exceptional mechanical shock.
1.12
Figure 1-3 shows a typical 18 line cabinet.
1.13
Figure 1-4 shows the electronics drawer pulled out for inspection.
1.14
Figure 1-5 shows the electronics drawer lowered for servicing.
1.15
Figure 1-6 gives the dimensions and mounting details of the suction fan blower assembly.
1.16
This unit must be mounted upright on a bulkhead.
1.17
Figure 1-7 shows the exterior of the blower cabinet as installed with flexible connections for the inlet, outlet and
olfactory line installed.
1.18
Figure 1-8 shows the blower cabinet door open and two suction fan blowers, manifold, two check (flapper) valves,
and two motor starters.
1.19
Figure 1-9 gives the dimensions and mounting details for the standard (1 to 24 line) repeater cabinet.
1.20
Figure 1-10 gives the dimensions and mounting details for the 25-48 line repeater cabinet.
1.21
Figure 1-11 shows the exterior of an 18 line repeater cabinet.
1.22
Figure 1-12 shows the interior of the 18 line repeater cabinet.
1.23
Finish colors are as follows:
a.
Smoke detector cabinet
1.
Front panels - black matte
2.
Balance of cabinet - fire engine red
1-2
