CONTROL PANEL (TYPE 5)
SYSTEMS OPERATION
C
GENERATOR MOUNTED CONTROL PANEL
(TYPE 5 - CHANGE LEVEL 12)
INTRODUCTION
The uses of the generator mounted control panel are: To help control
the electric power made by the generator set.
To monitor (check) the operation of the generator set.
To help protect the generator set from damage caused by low oil
pressure, high coolant temperature, overspeed and overcrank.
To help with the transfer of electrical load to and from the generator
set.
To help parallel two or more units onto the same bus.
IDENTIFICATION
The location of the control panel is on the top of the regulator housing.
This panel has a place for a heat switch and Prealarm module. The
shutdown indicators are relay lamp type. The control panel has a 13
place model number on the panel nameplate located inside bottom
surface of control panel. The model number gives an indication of the
control panel component part numbers. Make reference to the Parts
Book,
GENERATOR
MOUNTED
CONTROL
PANEL,
Form
No.
SEBP1068. The last two digits of the model number are the change
level to which the panel was built.
WIRING
See the pages that follow for wiring diagrams, schematics and
photographs for identification.
232
