TM 5-3825-226-24
TORQUE CONVERTER
6.
Install the bearings and retainers in two
gears (5). Make sure the threaded hole in
the retainer is toward the bottom of gears
when they are installed.
7.
Put two gears (5) in position in the
converter housing as shown. Install bolts
(6) that hold them. Tighten the bolts to a
torque of 36 + 2 lb.ft. (46 + 3 N-m).
8.
Install adapters (7) in both gears. Install
rings (8) that hold the adapters in position.
9.
Put shaft (I0) in a vise as shown. Do not
damage the splines on the shaft.
10.
Install ring (9) with tool (D).
3-167