TM 5-3825-226-24
INSTALL LOAD TRANSFER CYLINDER
NOTE: Attach hoist to cylinder before installing
bolts (1), washers (2) and cap (3).
1.
Replace
bearings
and
hoist
cylinder
into
position. Replace cap (3), four washers (2) and
bolts (1). Tighten bolts and remove hoist.
2.
Remove jumper hose from fitting under walkway
and from dump and lift valve.
3.
Connect two hoses; one to the dump and lift
valve, and one to the fitting under the walkplate
near the right front fender.
4.
Start the engine, extend the cylinders, and stop
the engine. Connect the load transfer axle
cylinder eyes to the lugs on the axle.
3-356