TM 10-3835-223-13&P
5-2. CONTROL CABLE REPAIR - cont.
(3)
Unscrew bezel (19). Remove key washer (18) and protective washer (17) from selector
switch (14).
(4)
(5)
(6)
(7)
Remove selector switch (14) and sealing washer (15) from cover plate (5).
Repeat steps (2) through (4) for selector switch S-3 (20) and selector switch S-2 (21).
Tag and disconnect electrical cable wiring from push button switch S-1 (7).
Unscrew bezel (2) and push button (1) from switch S-1 (7). Remove key washer (3) and
protective washer (4).
(8)
Remove switch S-1 (7) and sealing washer (6) from cover plate (5).
(9)
Remove screw (13) and disconnect ground wire from switch box (8).
(10)
Loosen knurled ring (12) and disconnect electrical cable (11) from switch box (8).
(11)
Loosen setscrew (9) and remove union (10) from switch box (8).
b.
Cleaning.
WARNING
Cleaning solvent is toxic and flammable. Use only in a well ventilated area.
Avoid prolonged breathing of fumes. Keep solvent away from flames. Do not
use in excessive amounts and avoid skin contact.
(1)
Wipe fuel, oil, and contaminants from switch box using a clean rag dampened with
cleaning solvent.
c.
(2)
Remove fuel, oil, and contaminants from face of cover plate (5).
(3)
Clean mating surfaces of switch box (8) and cover plate (5). Remove particles of sand,
gravel and accumulations of dirt from switch box seal.
(4)
Remove corrosion, dirt, and oil from electrical cable connector.
(5)
Wipe fuel, oil, and contaminants from electrical cable insulation.
Inspection.
(1)
Inspect electrical cable wiring for chafing, and burned, cut or missing insulation.
(2)
Inspect switches (14,20,21, and 7) for cracks, missing hardware or decals, signs of
overheating, and corrosion.
5-2
