TM 10-3835-223-13&P
5-2. CONTROL CABLE REPAIR - cont.
d.
e.
(3)
Inspect cover plate (5) and switch box (8) for cracks, bends, and corrosion.
(4)
Inspect electrical cable (11) for chafing, burns, and cut or missing insulation. Inspect cable
connector for broken pins and stripped threads.
Repair.
(1)
If defective, replace selector switches and push button switch.
(2)
If defective, replace electrical cable.
(3)
If defective, replace cover plate and switch box.
Assembly.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
Screw union (10) into switch box (8) and tighten setscrew (9).
Thread electrical cable (11) wiring into switch box (8). Connect electrical cable to switch
box (8) and tighten knurled ring(12). Connect ground wire to switch box with screw (13).
Position push button switch S-1 (7) and sealing washer (6) on cover plate (5). Install
protective washer (4). key washer (3), bezel (2), and push button (1) on push button switch.
Connect electrical cable wiring to push button switch S-1 (7), as marked during
disassembly.
Position sealing washer (15), and selector switch S-4 (14) on cover plate (5).
Install protective washer (17), key washer (18), and bezel (19) on selector switch (S-4) (14).
Connect electrical cable wiring to selector switch S-4 (14), as marked during disassembly.
Repeat steps (5). (6) and (7) for selector switch S-2 (20) and selector switch (S-3) (21).
Remove tags.
Position cover plate (5) and attached switches on switch box (8).
Install six screws (14).
5-4
