TM 10-3835-223-13&P
5-7. ELECTRICAL ENCLOSURES REPAIR -cont.
c .
Cable Box (Slave Cable Junction Box) Repair.
(1)
Removal. Remove the cable box enclosure as follows:
(a)
Disconnect cable assembly (55) from electrical enclosure (main junction box)
(para.5-7a(1)).
(b)
Remove four nuts (50), washers (51 and 58), lock washers (59), screws (60) and
connector cover (57) from enclosure bracket (52).
(c)
Loosen screws on cable assembly backshell (56) and unscrew backshell from cable
assembly connector.
(d)
(e)
(f)
Disconnect cable assembly (55) from enclosure bracket (52).
Remove four screws (67), washers (66), and cover (44) from enclosure (49).
Remove four screws (45), lock washers (46), flat washers (47), and enclosure (49)
from power pack weldment (21).
(g)
Remove four nuts (53), lock washers (541, washers (70), screws (62) and
washers (63).
(h)
Identify and tag electrical cable (65) leads at connector (64). Remove two
screws (69) and washers (68), then remove connector plug (64), cover (61) and
electrical cable (65) from enclosure (49).
(i)
Remove grommet (48) from enclosure (49).
NOTE
Repair of the cable box is limited to replacement.
(2)
Installation. Install cable box enclosure as follows:
(a)
Install grommet (48) in enclosure (49).
NOTE
Make sure leads are connected as marked during removal. (Refer to schematic
on main enclosure lid.)
(b)
Push electrical cable (65) through grommet (48) and into enclosure (49). Connect
electrical cable (65) leads to connector (64) using two screws (69) and washers (68).
(c)
Position connector plug (64) and cover (61) on enclosure (49). Install four
washers (63), screws (62), washers (70), lock washers (54) and nuts (53).
5-24
