TM 10-3835-223-13&P
5-7. ELECTRICAL ENCLOSURES REPAIR - cont.
b.
Enclosure Assembly (Solenoid Junction Box) Repair.
(1)
Removal. Remove the starter solenoid enclosure as follows:
(a)
Loosen screw (25) and raise enclosure lid (24).
(b)
Tag and disconnect cable assemblies (36 and 39) from solenoid (41).
(c)
Remove ferrule (40) from connector (38). Remove cable assembly (39) from
enclosure (32).
(d)
Remove lock nut (43) from connector (37). Remove cable assembly (36) from
enclosure (32).
(e)
Remove four screws (33), lock washers (35), and washers (34).
Lift solenoid enclosure (32) from power pack weldment (21).
(2)
Repair. Repair the starter solenoid enclosure as follows:
NOTE
Repair of the starter solenoid enclosure assembly is limited to replacement of
defective solenoid and/or enclosure.
(a)
Remove four screws (29) and separate solenoid (41) and panel (42) from
enclosure (32).
(b)
Remove two lock nuts (31), washers (30 and 28), and two screws (27). Separate
solenoid (41) from panel (42).
(c)
Position replacement solenoid (41) on panel (42). Install two washers (28 and 30),
screws (27) and lock nuts (31).
(d)
Position panel (42) and attached solenoid (41) in enclosure (32) and install four
screws (29).
(3)
Installation.
(a)
Position solenoid enclosure (32) on power pack weldment (21).
(b)
Install four washers (34), lockwashers (35) and screws (33).
(c)
Position cable assembly (36) end in enclosure (32) mounting hole. Install lock
nut (43) on connector (37).
(d)
Position cable assembly (39) in enclosure (32) mounting hole. Install ferrule (40) on
connector (38).
5-22
