TM 10-3835-223-13&P
5-7. ELECTRICAL ENCLOSURES REPAIR.
This task consists of:
a. Enclosure Assembly (Main Junction Box) Repair
b. Enclosure Assembly (Solenoid Junction Box) Repair
c. Cable Box (Slave Cable Junction Box) Repair
INITIAL SET-UP:
Tools required:
Tool Kit, General Mechanics, Automotive (Appendix B, Section III, Item 1)
Took Kit, Automotive Electrical (Appendix B, Section III, Item 3)
Material Required:
Solvent, Dry Cleaning (Appendix E, Section II, Item 5)
Tag, Marker (Appendix E, Section II, Item 6)
Equipment Condition:
Control cable removed from power pack (para. 4-13)
a.
Enclosure Assembly (Main Junction Box) Repair.
NOTE
Repair of the electrical enclosure is limited to replacement. Make sure
electrical cables are installed in the same enclosure mounting holes from
which they were removed. Electrical wiring may be to short if cables are not
mounted correctly.
(1)
Removal. Remove enclosure (junction box) as follows;
(a)
Loosen two screws (19), reposition brackets (20), and lift enclosure lid (21).
NOTE
To aid installation, tag location of electrical cables where they enter enclosure.
(b)
Tag and disconnect electrical wiring from terminal board TB-1(24).
(c)
Remove ferrule (23) from connector (1). Pull cable assembly (2) from
enclosure (5)
(d)
Repeat step (c) for corrugated (ribbed) cable assemblies (3,4,6,7,8, and 9).
(e)
Remove lock nut (18) from connector (17). Pull cable assembly (16) and connector
from enclosure (5).
(f)
Remove screw (13) and disconnect ground wire.
5-18
